Car Wont Start After Installing The T-One Vehicle Wiring Harness On Mitsubishi Outlander 2012
Updated 01/09/2017 | Published 01/06/2017
Question:
I install the harness for Mitsubishi Outlander 2012. After I finished installed my car battery die out?
asked by: Brandon
Expert Reply:
On your 2012 Mitsubishi Outlander, the installation of the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118518 should not have drained your battery if wired correctly. I've attached an installation video for you.
You may have a power draw somewhere in your system if it won't start after a prolonged period after installation issue. If it won't start immediately after installation, you will need to check your power connections. If you power connections are solid, I suggest charging your battery and then having it checked. If it is your original battery in the vehicle, it may have just been on the edge before the install.
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Vehicle Will Not Start After Installing Curt T-Connector Trailer Wiring Harness # C56012
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Wiring Harness for a 2011 Mitsubishi Outlander
- Q&A: Replacement Disc Brake Caliper for a Tie Down Engineering 46304 Caliper