Vehicle Will Not Start After Installing Curt T-Connector Trailer Wiring Harness # C56012
Published 08/28/2015
Question:
will not start after installing wiring harness. turns over, won't start. can you explain
asked by: Joe
Expert Reply:
It is possible that during the installation of the fuses and relays that something got knocked loose or damaged. Check the fuse panels where those items were installed and see if anything is damaged or missing. Also, make sure the relays are in the correct orientation. I have included a picture showing the relays in the correct orientation.
Installation of the wiring harness, # C56012, should not cause the vehicle to not start. You can test this by completely removing the harness, 3 fuses, and 2 relays, essentially putting the vehicle back to the state it was in prior to installing the harness.
If the vehicle does then start then there could be some fault in the harness and it should be replaced.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- No Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Wiring Harness and Relays for a 2025 Nissan Frontier
- Q&A: Install Instructions and Install Video for Convert A Ball Fifth Wheel to Gooseneck Adapter
- Q&A: Flat Tow Wiring and Trailer Wiring for a Jeep Grand Cherokee 2024 XE Hybrid
- Q&A: Recommended Trailer Hitch, Wiring and Brake Controller for a 2023 Jeep Cherokee L W/ "B" Prep Group
- Q&A: Why Would Trailer Hitch Install Hardware Seem Like it's Too Big to Fit
- Q&A: Recommended Parts To Flat Tow a 2021 Ford F-150 Hybrid
- Q&A: Parts Needed To Flat Tow a 2021 Ford F-150