Diameter of the Valves on Valterra RV Plumbing - T1002B
Published 12/06/2016
Question:
Is this a 2inch hub on both sides?
asked by: Larry
0
Expert Reply:
The Valterra Waste Valve part # T1002B is for 2 inch hose but since one side is designed to fit over the hose and the other side for inside the hose one side has an internal diameter of 2 inches and the other has an outer diameter of 2 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra Bladex Waste Valve for RV Holding Tank - 2" Diameter - Hub to Hub
- RV Waste Valves
- Straight Valve
- Single Waste Valve
- 2 Inch Valve Body
- Manual
- 2 Inch Hub
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: What Gas Detector do I Need to Replace My Old Atwood Model LP_DOB Part 31013 in My Airstream?
- Q&A: Propane Detector Replacement For Older Atwood 33535E
- Article: Trailer Lighting Requirements
- Q&A: Parts Included in Valterra RV Waste Valve T50A
- Q&A: Adding a Blade Valve to the end of my Tanks Dump Plumbing
- Q&A: Recommended Solar Panel Expansion Kit that Works w/ Go Power GP-PV-200M Solar Panels
- Q&A: Removal and Installation of Valterra Gray Water Tank Reducer
- Q&A: What Kind of Sealant is Used to Install Valterra Eccentric Tank Reducer # T1041-1
- Article: How Much Solar Power Do I Need For My RV?
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: How to Measure for Motorhome Steps