Connection Fittings for Roadmaster Airline RM450700

Question

Question:

Do you have the fittings to connect airline RM450700. I have the brackets with connections but need to make a longer replacement line?

asked by: Robert G

0

Expert Reply:

The ferrule fitting for use with the air line part # RM450700 are the part # RM-450740. Or if you are looking for the quick disconnect fittings you would want the part # # RM-921004-80.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Kent, The Roadmaster Nighthawk All-Terrain Tow Bar w/ LED Lights #RM-676 is a great tow bar to start off your component list with. It's going to include safety cables, a 7-wire to 6-wire adapter cable, and s 6-pole socket. You'll need the…

view full answer...

Answer 5

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Answer 6

To add a 100 lb tank to your two 30 lb tanks, I recommend the MB Sturgis Sturgi-Stay T-Fitting w Hose - Type 1 Valve - Quick Disconnect, Disposable Cylinder Ports #103615. This will allow you to connect the red fitting to one of your tanks and the…

view full answer...

Answer 7

Hey John, To start off you can thread the tee from the MB Sturgis Sturgi-Stay T-Fitting #103538-MBS and then use the include hose to thread into the second tank and plug it into one of the two quick disconnect ports to connect the tanks together.…

view full answer...

Answer 8

For your propane tank with fill valve, you most likely need the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L - 160,000 Btu/Hr #CAM59333. This will have the 1/4 inch NPt inlet and the 3/8 NPT outlet and will maintain a constant 11 inch water…

view full answer...

Answer 9

There are differences that the colors reference for the Type 1 Propane connectors based on the spring tension and flow rate. The light green connectors are rated for Rated for 200,000 Btu per hour. The black are rated for 70,000-100,000 Btu per hour.…

view full answer...

Answer 10

You'll be able to connect your Weber Traveler Grill directly to that quick-disconnect fitting using a hose like the MB Sturgis #100476-120-MBS as long as your grill doesn't have a regulator. If it does have a regulator then you need a tee…

view full answer...

Answer 11

The difference between the prices of the JR Products Automatic Changeover LP Gas Regulators and Camco Automatic Changeover 2-Stage Propane Regulators are in the BTU per hour, which as you correctly noted, is important information. The JR Products…

view full answer...

Answer 12

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Connection Fittings for Roadmaster Airline RM450700

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching