Fulton Jack to Replace Swivel Jack on Ranger Trailer
Published 11/08/2016
Question:
Hello, I have a Ranger Trailer with a Fulton side wind swivel jack. It has 8inch of lift and rated at 1200lb. It mounts to a bracket welded to the frame and the bolt centers are 5.5inch width and 3inch height , but is not held together with a snap ring, but a bolt. Do you have a direct replacement for it? I do not want to modify the trailer frame. Thank you
asked by: Bruce W
0
Expert Reply:
Based on what you described it sounds like the part # FTJ120W0301 is what you need. If the inner diameter of the welded on mount on your trailer for the jack is 2-1/4 inches it is the same mount that the # FTJ120W0301 would fit.
expert reply by:
Jameson C
0
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommendation to Replace Shelby 5756A Trailer Jack
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Is there a Higher Rated Fulton Jack that Uses the Same Swivel Mount as My TJ120W0301?
- Q&A: Replacement for Fulton Magnum Series Trailer Jack
- Article: Best Boat Trailer Jacks
- Q&A: Replacement Jack for Bulldog Model 130 Marine Jack
- Q&A: Replacement For Shelby 5776 Trailer Swivel Jack
- Q&A: Jack Recommendation to Replace Shelby Jack 5754A on Trailer
- Article: Trailer Maintenance Schedule
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How To Read A Tire Sidewall