7-Way to 4-Way Adapter Recommendation for Connecting from RV to Towed Vehicle
Published 11/08/2016
Question:
I am going to flat tow my 2016 Kia Soul behind a 2008 Winnebago Aspect. I have the towing parts which you sent just fine. I need the electrical hookups to Soul from motorhome that would be without LED lights attached. My Winne has 7 prongs and my Soul has 4
asked by: PAUL
0
Expert Reply:
The Hopkins Nite-Glow 7-way to 4-way flat coiled adapter, part # 47015 will work with the 7-way on your RV and then would plug into the 4-way. It would plug right into the connector at the front of the towed vehicle.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Adapter 7 Pole to 4 Pole with Flex-Coil Wire and Nite-Glow (TM)
- Custom Fit Vehicle Wiring
- Wiring Adapters
- Universal Fit
- 7 Blade to 4 Flat
- Plug and Lead
- Hopkins
more information >
Continue Researching
- Q&A: What Do I Need To Get A 7 Pole Connection On My 2024 Honda Pilot?
- Q&A: How To Know If Your Tiffin Motorhome Has A Towed Air Brake Setup Or BrakeSync
- Q&A: What Gauge Wire will Fit Into a Vehicle Side 6-pole Round Trailer Connector
- Q&A: Comparing Demco Hijacker and Pullrite Superglide Fifth Wheel Hitch for 2017 Ram 2500
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Q&A: Parts Needed to Flat Tow a 2015 Fiat 500 Pop Behind and RV
- Q&A: Parts Needed to Flat Tow 2022 Jeep Wrangler
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Raise Your Travel Trailer Height