Longer Battery Bolt Terminal Extender Recommendation
Updated 11/08/2016 | Published 11/07/2016
Question:
I just purchased some GM battery terminal extenders. However they do not fit into the rubber hole on the terminal cable where the original terminal bolt was. I removed the original side-terminal battery bolt, but the rubber hole is too small to be able to the new terminal extender far enough for the treads to reach into the battery. It is the hex part of the bolt that does not fit into the rubber hole. Do I have to cut away the rubber? I need the extenders to install a brake controller.
asked by: Charles
Expert Reply:
Sounds like you are in need of the part # DW05417. This is a longer bolt extender that has the threaded section longer to allow an easier install. I am not sure which one you have though but I would not recommend trimming back the battery.
Product Page this Question was Asked From
Brass Battery Terminal Bolt Extender - Long Side Terminal - 3/8"-16 Thread x 1-13/16" Long
- Accessories and Parts
- Battery Boxes
- Bolt Extenders
- Deka
more information >
Continue Researching
- Q&A: Recommended Cover for a 2023 Lance 2285 Travel Trailer
- Q&A: Recommended Easiest Bike Rack to Load a Heavy E-Bike
- Q&A: What Is An OEM Prep Package And How Do I Know If I Have It
- Q&A: Most Comfortable Short Queen Mattress For Trailer
- Q&A: Can the Denver Mattress Rest Easy Short Queen RV Mattress Be Used In Murphy Bed
- Q&A: 5th Wheel Base Rails to Fit 2015 F-550 Cab and Chassis With Custom-Made Service Body
- Q&A: Recommended Replacement Grease Seal with 2.561-Inch Outer Diameter