Pigtail Recommendation for Use with Clearance Light Part STL22RCB for Additional Clearance
Published 11/02/2016
Products Featured in This Question
Question:
Hello i bought Part # STL22RCB and pigtail part #A45PB found out when installing it the pigtail was too far out the back yes the pigtail was pushed all the way in i was wondering if putting part #A47PB pigtail on would it be less sticking out the back . The inside dia of the frame is 1 3/4 inches thank you very much.
asked by: Randale S
0
Expert Reply:
You are absolutely correct. The 90 degree pigtail part # A47PB would give you the needed clearance to install the part # STL22RCB. This would be exactly what you need.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Miro-Flex LED Trailer Light w/ Reflector - Brake, Tail, Turn - Submersible - Oval - Red - Clear Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2-5/16W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Brake Assemblies, Hubs, and Bearing Kit for a Dexter 3,500 EZ Lube Axle
- Q&A: Do Thinline LED Clearance and Side Marker Lights Come With Bracket and Wiring
- Q&A: Replacement for TDE LP85 Surge Brake Actuator
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Q&A: How to Wire the Dexter Electric Over Hydraulic Trailer Brake Actuator
- Article: Trailer Wiring Diagrams
- Q&A: Comparing Brightness Ratings of Optronics LED Tail Lights
- Q&A: Wiring for Clearance and Turn Signal Functions with Clear Lens 2 Wire LED Light
- Article: Trailer Lighting Requirements
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012
- Article: Holiday 2025 | Best Gifts for RVing
- Article: Holiday 2025 | Best Gifts for Towers