What Size Mounting Bolt Should be Used for Pollack Mounting Bracket # PK11771?
Updated 09/19/2016 | Published 09/17/2016
Products Featured in This Question
Question:
item: PK11771, the drawing dimensions look 2.25 inch center of the slot. will it accommodate 2.5 inch center 1/4inch bolts?
asked by: Sid
0
Expert Reply:
The diameter of the top mounting hole on # PK11771 is 5/8 inches long by 5/16 inches wide. This means that a 1/4 inch bolt would work great to attach this mounting bracket like the self tapping # FA1131822.
I have linked the above mentioned products to this page for your convenience.
expert reply by:
Jackie C
0
Product Page this Question was Asked From
Pollak Bracket for Single-Pole Trailer Wiring Socket
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 1 Round
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Complete Flat Towing Setup for a 2026 Ram 2500 Behind a Motorhome
- Q&A: Will Blue Ox Bulb and Socket Tail Light Wiring Kit for Towed Vehicles Work on My 2024 Jeep Gladiator
- Q&A: How to Run a Charge Line to a 4-Way Connector
- Q&A: Parts Needed to Install Demco Air Force One on Spartan K2 Chassis
- Q&A: Adding A Propane Gas Quick Connect Under Trailer
- Q&A: Blue Ox Patriot Supplemental Braking System Power Draw
- Q&A: Recommended Flat Towing Equipment For A 2022 Ram 2500
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: How to Bleed Your Trailer Surge Brakes