Would CIPA Clamp On Mirror CM49504 Fit Semi West Coast Mirror
Published 08/30/2016
Question:
Will the CM49504 clamp on to my west coast mirrors on my 1986 S2500 truck tractor right side mirror with out covering the mirror itself giving me more coverage of vehicles on that side of the truck. This is a tandem truck with a 22 foot bed.
asked by: Steven B
Helpful Expert Reply:
All I can really say is that the mirror part # CM49504 that you referenced measures 4 inches tall and 8 inches long. When mounted properly it's designed not to obstruct the view of the original mirror of the vehicle.
The CIPA clamp-on mirror, # CM49504, is designed to clamp to a round mirror bracket on a factory mirror. I looked up your mirrors and these should work fine on them.
Product Page this Question was Asked From
CIPA Clamp-On HotSpot Mirror - 4" x 8" - Convex
- Blind Spot Mirror
- Convex
- Clamp-On
- Rectangle
- CIPA
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Thermostat for Dometic 3316410.012
- Q&A: Remote Replacement For The Lippert 2-Function Hydraulic Wireless Remote
- Q&A: Is Wall Thermostat/Controller Required for Furrion RV Tankless Water Heater
- Q&A: How Hard Is It To Replace The Gears In HappiJac 4500-Series Camper Jacks
- Q&A: Recommended Replacement for Dometic Traveler Lite 111
- Q&A: Choosing Between the CIPA and K-Source Universal Towing Mirrors for a 2008 Ford Expedition
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Hitch and Ground Clearance for a 2006 Toyota Matrix XRS and Curt Trailer Hitch # C12013
- Article: Converting Your RV Water Heater to Tankless
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft