How to Get to the Custom Tuning Options on an Edge Evolution CS2 Programmer
Updated 08/15/2016 | Published 08/12/2016
Question:
How to set the shift points on tramission
asked by: Gary
Expert Reply:
On the Edge Evolution CS2 programmer # EP85350 you can get into the custom programming from the quick link menu. Then you go to performance tuning, pick a level, choose a tune. Then it will ask to continue, choose yes. At this point it will ask Custom Program? and you can select yes and it will bring up the custom options menu.
Not all options are available on all vehicles though so while the programmer may have the ability to make certain changes the vehicle computer may not allow everything that the programmer is capable of.
Product Page this Question was Asked From
Edge Gas Evolution CS2 Performance Tuner- Color Screen
- Performance Chip
- Performance Tuners
- Tuner Only
- Color Screen
- No - Not California Approved
- Evolution
- Edge
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Increase Towing Power in 2003 Chevrolet Avalanche 1500 with 5.3L V8 Towing 7600-lb Trailer
- Article: Converting Your RV Water Heater to Tankless
- Article: Most Popular Wheel Bearings
- Q&A: Edge Evolution Programmer for a 2015 Chevy Silverado 2500HD with 6.0 Liter Motor
- Q&A: Horsepower Gains for 2014 Chevy Silverado 5.3L with Programmer, Cold Air Intake, and Exhaust Mods
- Q&A: I Have Replaced Parts Before With No Issue, Why Is My Superchips Flashpaq F5 Not Working Right Now
- Q&A: Will Edge CTS3 Programmer Fit 2011 Chevy Silverado with 6.0 and Basic Bolt Ons
- Article: Performance Chips and Modules
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Parts Needed To Install a Trailer Brake Controller on a 2024 Ford Ranger
- Q&A: Complete Snow Plow With Front Hitch And Suspension Upgrade For 2018 Ford F150 4WD Plowtruck