Can the Edge EZ Programmer be Used without the Toggle Switch
Updated 07/12/2016 | Published 07/11/2016
Question:
Do you need the toggle switch? Can u run on level 3 with out it ??
asked by: Jake
0
Expert Reply:
The toggle switch with the Edge EZ programmer # EP30204 is needed to select the power level you want. If you do not want to mount the switch inside the vehicle then you could leave it under the hood as long as the cable and switch are protected and not touching anything that gets hot like the block or exhaust as well as away from any moving parts. Then you could set the switch to the desired power level and then leave it alone.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Edge EZ for Dodge Cummins 5.9L, 24V, Common Rail
- Performance Chip
- Performance Tuners
- Tuner Only
- No Display Screen
- Yes - California Approved
- EZ
- Edge
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Toggle Switch Positions on the Edge EZ Programmer 30204
- Q&A: Replacement Switch and Cable Recommendation for Edge EZ Programmer # EP30204
- Q&A: Can I Use Hubs with 3500-lb Capacity on Axle with 1750-lb Capacity If The Bearings Match Up?
- Q&A: Does the Edge EZ Tuner # EZD1000A Come with a Switch to Adjust Power Levels
- Q&A: Replacement Hub for Older Dexter 8-245
- Q&A: Bearing Kit Recommendation for Dexter 8-248 Hub
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Most Popular Wheel Bearings
- Article: How to Measure for Trailer Hitch Drop