Tie Down Anchor Recommendation for Trailer That Has 3/4 inch Depth Restriction
Published 07/07/2016
Products Featured in This Question
Question:
I have an installation question. With my particular installation, the depth of the hole is limited to a depth of only 3/4inch deep. Will the Brophy RR5K be able to fully recess into a hole that is only 3/4inch deep? Thanks.
asked by: Blain O
Helpful Expert Reply:
I have a solution for you, but the part # RR5K would stick down too far for the hole you have that only can fit 3/4 inches of depth. For a similar rated tie down anchor that surface mounts instead you would want the part # LRB1 which has a 4k capacity.
I attached an install video for you to check out as well.
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor w Backing Plate - Bolt-On - 1/2" Wide - Recessed - 1,600 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 1600 lbs
- Bolt-On
- Folding
- Recessed Mount
- Brophy
more information >
Continue Researching
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Mounting Hole Spacing For Square D-Ring Tie-Down Anchor ABS69FR
- Q&A: Parts Needed To Flat Tow 2025 Ford Ranger
- Q&A: Can Brophy D-Ring Tie Down Anchor Install on Steel Floor
- Q&A: Is There a 4-Way Wiring Harness for a 2026 Chevy Equinox Activ?
- Q&A: Replacement Bearings For A 6,000 Pound Dexter Axle
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Recommended Backing Plate for the Square D-Ring Tie-Down Anchor ABS69FR
- Q&A: Bearings and Grease Seal for Terran Axle Idler Hub
- Article: Trailer Hitch Receiver Sizes
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Where to Position the Trailer Axle?
- Article: Cargo Tie-Down Methods
- Article: What To Look For When Buying Ratchet Straps