Can the Enclosed Ramp Spring CB250D96SHD Be Trimmed Down to 81 inches
Published 07/07/2016
Question:
I would like to know if I can cut it down to 81 inches to work on my trailer I have a 2005 haulmark trailer 7x14 Thank you
asked by: Tom
0
Expert Reply:
Yes, you could trim down the ends of the Enclosed Trailer Ramp Spring # CB250D96SHD to take it down to 80 inches minimum. If you need anything shorter, then I recommend using the 94 inch # 362SW81 instead to give you a few more inches to play with.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Conventional Ramp Door Spring for 8' Wide Enclosed Trailer - Dual Spring - 250-lb Capacity
- Trailer Ramp Springs
- Dual Ramp Spring
- Torsion Spring
- 150 Inch Cable
- 231 - 250 lbs
- Conventional Spring
- 6 Foot Wide Trailer
- 7 Foot Wide Trailer
- 8 Foot Wide Trailer
- 94 Inch Wide Spring
- M-3 and Associates
more information >
Continue Researching
- Q&A: How to choose the correct conventional ramp door spring
- Q&A: Weight Capacity Options for a 6 ft. Wide Ramp Door Spring
- Article: Trailer Wiring Diagrams
- Q&A: How to Add a 7-Way Connector for a 2023 Ford Bronco w/out the Factory Towing Package
- Q&A: Does Dual Ramp Door Spring Turn Each End Independently
- Q&A: Choosing the Correct Replacement Spring for an Enclosed Trailer Ramp Door
- Q&A: Replacement Drum and Cable for Trailer Ramp
- Q&A: Best Way to Clean Streaks on Canvas Tent Trailer
- Article: How to Choose a Trailer Hitch Coupler
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review
- Article: Ram Trailer Tow Prep Package
- Article: How to Install E-Track in 3 Easy Steps