How Does Driver Side WeatherTech Floor Mat WT444591 Release from Floor
Published 06/08/2016
Question:
I cant get the Drivers floor mat out to clean. How do I get it loose from holder?
asked by: Cynthia C
0
Expert Reply:
There are two posts that hold the floor mat part # WT444591 to the driver side of your vehicle. If you look on the top of the mat you will see two circular pieces that are above the posts. You would need to pull up on the mat till the posts release from the mat.
I attached an install video that shows the mats getting installed and pressing onto the posts.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
WeatherTech Front Auto Floor Mats - Black
- Floor Mats
- Custom Fit
- Rubber
- Front
- Contoured
- Black
- WeatherTech
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Flat Tow Setup for a 2026 Ford Maverick
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Firestone Air Bags for 2026 Ford F-350 FX4 Dually
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Rooftop Cargo Carriers