Can Edge EZ Module Be Stacked with Edge CTS 2 Programmer
Updated 06/02/2016 | Published 06/01/2016
Question:
Can a Edge EZ tunner be hooked up with a Cts 2 edge tunner on a 2007 dodge
asked by: Shawn
0
Expert Reply:
You do not want to stack programmers on your vehicle. Doing so will cause damage as they are both designed for use with a stock PCM.
The Edge EZ module has three levels:
Level 1: 25 Horsepower - 50 Foot Pounds of Torque
Level 2: 45 Horsepower - 75 Foot Pounds of Torque
Level 3: 65 Horsepower - 150 Foot Pounds of Torque
But can only provide that power on a stock tuned PCM.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Edge EZ for Dodge Cummins 5.9L, 24V, Common Rail
- Performance Chip
- Performance Tuners
- Tuner Only
- No Display Screen
- Yes - California Approved
- EZ
- Edge
more information >
Continue Researching
- Q&A: Toggle Switch Positions on the Edge EZ Programmer 30204
- Q&A: Replacement Switch and Cable Recommendation for Edge EZ Programmer # EP30204
- Q&A: Can I Use Hubs with 3500-lb Capacity on Axle with 1750-lb Capacity If The Bearings Match Up?
- Q&A: Does the Edge EZ Tuner # EZD1000A Come with a Switch to Adjust Power Levels
- Q&A: Replacement Hub for Older Dexter 8-245
- Q&A: Bearing Kit Recommendation for Dexter 8-248 Hub
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Most Popular Wheel Bearings