Tips for Getting 4 Wires to Fit in Power Grip Replacement RV Power Cord Plug
Updated 05/17/2016 | Published 05/13/2016
Question:
How do I wire it with 4 wires the green wire will not let the plug back close Thanks
asked by: Jerry J
Expert Reply:
You might need to remove any loom or jacket on the wires you are using (the black part in the pictures/video we show) so that it is not sandwiched between the 2 halves of the plug, # CAM55255. It might also help to manipulate and move around wires enough to be able to get the screws started.
But loom or jacket can be pretty stiff and hard to compress so having just the 4 insulated wires not contained in a loom or jacket would make it easy to close it all up.
Product Page this Question was Asked From
Power Grip Replacement RV Power Cord Plug w/ Handle - 50 Amps - Male
- Accessories and Parts
- Generator Plug Adapters
- Marine Power
- RV Plug Adapters
- RV Power Cord
- Plugs and Sockets
- Male Plug - 50 Amp
- Camco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Best Rear Suspension Enhancement Kit Recommendation for 2021 Chevy Silverado 2500
- Q&A: Can Progressive Dynamics 9300 be Wired to Parallel Battery Bank
- Q&A: Recommended Replacement Motor For A Greystone RV Range Hood Vent
- Q&A: Recommended Replacement For A Suburban SW6DE Water Heater
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Replacement Recommendation for Sylvania Microwave SR-11092
- Q&A: Looking For Replacement Pitch Arm For Solera 3000 Awning With 63" Support Arms
- Q&A: Recommended Fairing for Rola Roof rack on a 2009 Honda Accord Sedan