Grease Seal Recommendation for a Trailer Hub With Inner Diameter 1.75 and Outer Diameter 2.72
Updated 05/11/2016 | Published 05/10/2016
Question:
Hello, I am having a hard time finding a seal for m trailer hub. it looks to be a possible automotive axle The measurements I have are 2.7269.08mm OD, 1.73243.99mm ID. I have a couple part numbers, 447008XXTimken, 44x70x8 National and 17179 SFK Do you guys stock anything like this?
asked by: Bjorn B
0
Expert Reply:
Based on the dimensions you listed the part # SL175 would work for you as it has an outer diameter of 2.722 inches and an inner diameter of 1.750 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Single Lip
- 1.75 Inch I.D.
- 2.72 Inch O.D.
- Redline
more information >
Continue Researching
- Q&A: Does TecNiq Round Side Marker Light TN54TR Come with Grommet
- Q&A: Replacement Inner Tube Gooseneck Coupler 4" Diameter For BullDog Bx1 25k
- Q&A: Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Replacement Reservoir Tank for Lippert Hydraulic Power Slide Out Unit
- Q&A: Replacement Locking Door Latch for 1994 Wells Cargo Trailer
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Solution for Needing Replacement Wesbar Trailer Taillights 403348
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub