Motor Stalls on Polaris 570 ATV when Using Superwinch LT3000ATV Winch
Updated 05/11/2016 | Published 05/09/2016 >
Question:
Engine stalls when roping in
asked by: Angelo
Helpful Expert Reply:
It sounds like the load on the winch you have on your Polaris ATV is creating too much power draw for the electrical system to handle causing the engine to die. It might not die if you keep the RPMs up enough to handle the increased load. You may also need to look into a higher capacity battery and/or generator/alternator to handle the higher load.
The Superwinch LT3000ATV winch # SW1130220 can draw up to 180 amps at full load. If the electrical system cannot handle that load or the battery is weak then it could stall out the motor.
Product Page this Question was Asked From
Superwinch LT3000 ATV Winch - Wire Rope - Roller Fairlead - 3,000 lbs
- Electric Winch
- ATV - UTV Winch
- Planetary Gear
- 1.0 HP
- 2001 - 4000 lbs
- 11 - 20 lbs
- Slow - 0 to 4 fpm
- Wired Remote
- Wire Rope
- Superwinch
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Solution for Replacement Winch for Old Starcraft Lift System
- Q&A: Locating the Brake Controller Connector on a 2017 Ford F-150 to Install the Hopkins # HM47294
- Q&A: Replacement Shelby 5438 Winch Recommendation for Pop Up Camper
- Q&A: Winch Recommendation for Pulling Racecar Up Into Trailer
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Article: How to Install E-Track in 3 Easy Steps
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Q&A: No Power At Brake Controller On 2007 Chevy Silverado Classic
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper

