To What Size Fuse Should Optronics Thin-Line LED Racing Light Kit Be Wired
Updated 04/29/2016 | Published 04/25/2016
Products Featured in This Question
Question:
What size fuse do I need to wire it to?
asked by: Cathy P
0
Expert Reply:
I spoke with my contact at Optronics about the amp draw of the Thin-Line LED Racing Lights # LS-108. He confirmed that each light will draw 0.08 amps, and as a set the lights will draw 0.16 amps.
With so little amp draw, you can tap these lights into whichever fuse works best for you.
If you need a fuse tap, you can use the Firestone Fuse Circuit Tap Kit # F2526.
expert reply by:
Victoria B
0
Product Page this Question was Asked From
Optronics ThinLine LED Racing Light Kit w/ Harness and Power Switch - 12 Diodes - Oblong - Qty 2
- LED Strip Lights
- Rigid Light
- Exterior Light
- Hardwired
- 0 - 10 Inch Long
- White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Do Slipper Springs Use Bushings on Both Ends?
- Q&A: How to Wire the Red Identification Light Bar with White LED Utility Light OPT88FR?
- Q&A: Is Bushing Required on Open Eye End of Slipper Spring
- Q&A: Installation of Slipper Spring with Open Eye End
- Q&A: Which Way Do Slipper Springs Face on a Trailer
- Q&A: Is It Normal For Open Eye Spring To Hit Frame Of Trailer When Loaded?
- Q&A: 27 Long Slipper Springs for a Boat Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)