How Tight Does the Curt Stud Mount Lunette Ring have to Be to Still Allow it to Swivel
Updated 04/11/2016 | Published 04/06/2016
Question:
How tightly must the fastener be tightened at installation yet still allow the swivel action? Should a large flat washer be installed on both sides to facilitate the swivel action?
asked by: K. G
0
Expert Reply:
You will want to be able to use the cotter pin to keep the nut in place on the Curt lunette ring # C48530. So it will need to be threaded in far enough for the pin to go through the shank of the ring to hold the nut on.
Using flat washers will be fine as long as the nut can still thread on far enough.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt Lunette Ring - Stud Mount - 3" Diameter - 45,000 lbs
- Lunette Ring
- Coupler with Nut
- Bolt-On
- 45000 lbs GTW
- 3 Inch Lunette Ring
- CURT
more information >
Continue Researching
- Q&A: Correct Lunette Ring With Nut To Fit a 1-1/2" Mounting Hole
- Q&A: Hub And Drum Recommendation For Lippert Trailer 7000k Axle
- Q&A: How Does Curt Stud Mount Lunette Ring C48520 Install on a Trailer
- Q&A: What is the 5-pin to 4-pin Adapter for RVS Side Camera?
- Q&A: Replacement Oil Cap for Dexter Hub # 21-35
- Q&A: Bearing Buddy for Hub Bore of 2.25-Inches
- Q&A: When Would a Trailer Break Away Kit Be Required By Law
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Dealer Spotlight - Hamilton Trailer Repair
- Article: Trailer Lighting Requirements