Front Mount Trailer Hitch And Spare Tire Carrier For 2013 Ford E-450

Question

Question:

What about a front hitch for a 2013 E450? Wanted to mount the spare tire somewhere on a 2013 Jayco E450 and it is either build a new rear bumper to replace the lightweight junk that is there now or better option would be a front mount hitch for a spare tire 16inch dual wheel type.

asked by: Earl C

0

Expert Reply:

The front mount trailer hitch we offer for a 2013 Ford E-450 RV Cutaway is the Draw-Tite Trailer Hitch, part # 65053.

For a hitch-mounted spare tire carrier I recommend part # C31006. This is a universal spare tire carrier. I have attached a photo of the carrier with some dimensions noted you can check out.

expert reply by: Jeffrey L

0

click to enlarge

Answer 1

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 2

Hey Greg! Is the picture you attached a picture of your motorhome? Assuming it is then yes, the EcoHitch Front Mount Trailer Hitch #EH99CR will fit your 2023 Tiffin Wayfarer Motorhome. What will you be using the hitch for?

view full answer...

Answer 3

Hey Jason, the install of the EcoHitch Front Mount Trailer Hitch Receiver #EH99CR does not affect the front sensors or cruise control. What will you be using the front hitch for?

view full answer...

Answer 4

Hey Sue, we have a front hitch that fits your 2022 Jayco Redhawk 24B with the Draw Tite part #65053 which would be exactly what you are looking for but the hitch you referenced only fits at the rear of vehicles. The #65053 definitely has the capacity…

view full answer...

Answer 5

Hi Donald; the #EH54QR is designed for the F-450 not the E-450 so it will not fit. I'm sorry to say there are no custom hitches made for the front of your motorhome. What you can do is take the #E17 to a local fabricator and have them fashion a…

view full answer...

Answer 6

The Progressive Dynamics RV Power Control Center #PD4135K is going to be the closest in dimensions to replacing the Magnetek model 80 power center you have. This control center fits inside a 10-1/4" long x 7" tall cutout and is 11-1/4"…

view full answer...

Answer 7

The Draw-Tite #65053 is a fit for the 2016 E450. I've confirmed this with Draw-Tite. This hitch has a 2 inch opening. I attached an install picture of this hitch installed on a similar E-450 as yours for you to check out as well.

view full answer...

Answer 8

Yes, the Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2" #65049 is confirmed to fit your 2015 Ford E-450. As you can see in the attached demonstration video, installation is simple and it does not require welding.

view full answer...

Answer 9

Hey Larry, the Dometic FreshJet 3 part #DMC69ZR that you referenced does not require an additional control board to work. Basically you just need to run the power wires to it and it' ready to go as the controls are internal and on bottom of the…

view full answer...

Front Mount Trailer Hitch And Spare Tire Carrier For 2013 Ford E-450

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching