Will Race Ramps Trailer Ramps Work When Loading Motorcycles In 2012 Work And Play Toy Hauler
Updated 03/21/2016 | Published 03/18/2016
Question:
I am looking for help getting my motorcycles loaded into my 2012 Work and Play toyhauler. They drag going across the ramp top into the garage. I am looking at your 45inch ramp with 6inch lift.
asked by: Shannon F
Expert Reply:
The best way to make sure the Race Ramps Trailer Ramps, part # RR-TR-6, will work for you is to measure the distance from the top of your ramp door to the ground.
If the distance from the top of your toy hauler door when it is open is 6 inches or less, then the # RR-TR-6 ramps should work great for you. These have a textured surface that helps prevent them from sliding and they are built with an 8.2 degree angle to help low to the ground vehicles like your motorcycles from scraping.
Product Page this Question was Asked From
Race Ramps Trailer Loading Assist Ramps - 6" Lift - 45" Long - Qty 2
- Car Ramps
- Loading Ramps
- Car Hauler Ramps
- 6 Inch Lift
- 3000 lbs
- No Attachment
- 14 Inch Wide
- 45 Inch Long
- Foam
- Race Ramps
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Wiring Diagram for a 1997 Peterbilt Semi Tractor with 7-Pin Round Connector
- Q&A: Tire Chains for Dually 245/75-17 Tires on a 2011 Ford Super Duty
- Q&A: Dually Tire Chain Recommendation for Tire Size 245/75-17
- Q&A: Wiring Diagram for 7-Way Round Pin Trailer and Vehicle Side Connectors
- Q&A: What is Bracket Height for etrailer 2 Swivel Jacks e34RV and e94RV
- Q&A: Will Race Ramps Trailer Loading Assist Ramps Help With Loading A Lowered 1955 Chevy Onto A Trailer?
- Q&A: Extended and Retracted Dimensions of the etrailer 2 Swivel Jacks w/ Bolt-On Mounting Plates
- Article: Trailer Lighting Requirements
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams