Bow Stop Setup Availability for a Boat Trailer
Updated 03/15/2016 | Published 03/13/2016
Products Featured in This Question
Question:
I am looking for the arm that the bow stop is bolted to . I do not know the name of the part but I think it is called Winch Stand The winch is bolted on at the beginning of this arm and the strap goes to the bow stop and to the boat ... I hope you understand what I want
asked by: Mr. L
0
Expert Reply:
I believe you are talking about a bow roller like the part # CE31005PG.
I recommend bow stop # YR7Y44-4 used with bracket # CE31005PG and shaft # CE10700A for your bow stop set up.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Roller Shaft with Cap Nuts for Boat Trailer Rollers - Zinc-Plated Steel - 5-1/4" x 1/2"
- Boat Trailer Parts
- Rollers
- Roller Shafts
- 1/2 Inch Diameter
- Zinc-Plated Steel
- 5-1/4 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: Replacement Axle Recommendation for 49.5 Spring Center and 59.5 Hub Face Measurements
- Q&A: Which is Better an EZ Lube Spindle or a Bearing Buddy Setup
- Q&A: Shafts for Rollers on Pontoon Boat Trailer are Welded On
- Q&A: How To Replace a Knot Autoflex Winch and Bow Roller Assembly On a Boat Trailer
- Q&A: Replacing a Shelby 1,000 lbs Trailer Jack With a Similar Fulton Jack
- Q&A: Compatibility of Fulton # F141133 XLT Trailer Jack with 3 x 2 Inch Trailer Frame
- Q&A: How Would Roller Bunks Install on Karavan Boat Trailer
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Slipper Spring Trailer Suspension System Review