Trailer Wiring Harness Recommendations for 2013 Ford Edge
Updated 02/15/2016 | Published 02/13/2016 >
Question:
I want to use this on my 2013 Ford Edge sport which has a factory connector at the rear. They recommend the 85350 connector but I have to wire a battery lead all the way to the front of the vehicle for that one. If I use the 85340, it looks like I do not need the battery lead and the brake lights will still work independently from the signal lights. Will the 85340 kit work on my Ford Edge? If yes, what are the risks? If no, can you explain why? Thanks
asked by: Rob V
Expert Reply:
To install a 4-pole trailer connector on your 2013 Ford Edge, I'd recommend the Tow Ready # 118515. This wiring harness does have a direct connection to the battery, this is done for a good reason. Years ago, you could tap into the taillight circuits to power your trailer taillights. The wires were of sufficient gauge so that plenty of power for both the vehicle and the trailer taillights could be drawn through the vehicle's taillight circuits. Now, due to cost restraints, the automobile manufacturers are using thinner gauge wiring that's rated for the vehicle taillights, but not the added burden of powering the trailer taillights as well. The converter gets signal from the taillights circuits, but the actual power needed to drive the trailer taillights comes directly from the battery.
Wiring the trailer connector this way also helps to isolate the vehicle's wiring from any short circuits that might occur in the trailer's wiring. The wiring on the trailer is much easier and much more inexpensive to repair than that of the vehicle.
The # TM85340 and the # TM85340 are a fit for the Saturn Vue/Chevy Equinox and wouldn't fit your Edge. If you click the provided link, you can see the wiring harness I recommended being installed on a 2013 Ford Edge.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Availability of 3036-P Wiring Harness for 2025 Ford E-450
- Q&A: Replacement Trailer Jacks for Existing Fulton Weld On Mounting Bracket
- Q&A: Which Weld-On Bracket Pairs With Fulton Boat Trailer Jack w/ Wheel
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trailer Hitch and Wiring for 2027 Kia Telluride
- Q&A: Underbed Gooseneck Hitch For 2020 Ford F-150 Short Bed
- Q&A: Which Draw-Tite Trailer Hitch Receiver Fits a 2013 Ford Edge SEL with Dual Exhaust
- Q&A: Inexpensive Trailer Hitch and Wiring Recommendations for a 2009 Ford Edge AWD to Tow a Boat Trailer
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Lighting Requirements
- Article: How Much Trailer Can I Really Tow
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Hitch Installation Tips


