Mounting Stromberg Carlson Extend-A-Shower Shower Curtain Rod When No Studs Are Present
Updated 02/15/2016 | Published 02/13/2016
Question:
Worried about mounting the rod. What is the best way if there are no aluminium studs.
asked by: John A
1
Helpful Expert Reply:
You will need to have a solid surface to mount the Extend-A-Shower. One customer said they did not have any studs to mount this to and used blocks.
You could do something similar by fabricating small mounting blocks to mount to the wall first, and then install the shower curtain rods.
expert reply by:
Jeffrey L
1
Product Page this Question was Asked From
Stromberg Carlson Extend-A-Shower Shower Curtain Rod for RVs - 35" to 42" - White
- Accessories and Parts
- RV Showers and Tubs
- Indoor Shower
- Curtain Rods
- White
- Stromberg Carlson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Breakaway Switch A UPG Model 42914 Breakaway Kit
- Q&A: Wiring Diagram for Kwikee Step Motor Conversion/Upgrade Kit # LC379145
- Q&A: Availability of Just Replacement Jack Leg of Lippert Ground Control 3.0 Leveling System
- Article: Ugly RV Makeover: How to Change Outdated RV Lighting
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Q&A: Should Wiper for RV Slide Out be Installed Upside Down
- Q&A: Correct Replacement Legs for Lippert Ground Control 3.0 Leveling System - 6 Point
- Q&A: Which TorkLift Tie-Downs For 2015 Toyota Tundra Double Cab 6-1/2' Bed
- Q&A: Replacement Legs for Lippert Components Ground Control 3.0 Electric Leveling System
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Top Gifts for Dads in 2024
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps