Recommended Bracket To Install 6-Way Connector On Front Of 2009 Honda CR-V
Updated 01/18/2016 | Published 01/16/2016
Products Featured in This Question
Question:
I have a 2009 Honda CRV where is the best place to mount this vehicle end connector in front ? do I need a bracket to install just under the license plate or do I just drill a hole through the plastic bumper?
asked by: Paul K
1
Helpful Expert Reply:
To install the RoadMaster 6-Wire Trailer Connector, part # RM-910030-7, you will need a bracket.
The bracket I recommend is the Roadmaster Bent Electrical Socket Bracket, part # RM-910030-5. You need to find a flat surface that can support the connector and bracket.
expert reply by:
Jeffrey L
1
Product Page this Question was Asked From
RoadMaster 6-Wire Trailer Connector - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 6 Round
- Plug Only
- Roadmaster
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Q&A: Complete Setup for Flat Towing 2026 Chevrolet Colorado
- Q&A: Recommended Option For Swapping Out A Lance Proprietary 6-Pole Socket
- Q&A: Is Norcold 12V RV Mini Fridge A Good Choice For Lance Truck Camper Off-Grid
- Q&A: Does etrailer Base Plate Kit for 2025 Ford Maverick Lariat Require ACC Sensor
- Q&A: Parts Needed To Flat Tow a 2018 Jeep Wrangler Unlimited JK With Factory Bumper If I Have a Tow Bar
- Article: Trailer Wiring Diagrams
- Q&A: How To Plug 1997 Lance Truck Camper Into 7-way Connector On 2016 Ford F-250
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Can You Flat Tow a 2024 Chevy Colorado?
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Flat Towing Package for 2025 Ford F-150