Installing Reese Replacement Crossmember Head Support # RP58147
Updated 01/18/2016 | Published 01/16/2016
Question:
Fastened the crossmember to its lowest position on the hitch. Looking at it from the side view, the top of the crossmember slopes slightly toward the front of the hitch......the 4 bolts and holes are all lined up so this must be the correct position. Can you confirm this please........... Thanx.
asked by: Nicklaus T
Expert Reply:
When properly installed the Reese Replacement Crossmember Head Support # RP58147 which fits their 5th Wheel hitch # RP58146 will slope rearward slightly if installed on a slider base. If used with a fixed hitch base it should be essentially level. It is possible that the unit is installed in a reversed position.
Product Page this Question was Asked From
Replacement Crossmember Head Support for Reese 5th Wheel Trailer Hitch - 16,000 lbs
- Accessories and Parts
- 5th Wheel Hitch
- Head
- Head Support
- Reese
more information >
Continue Researching
- Q&A: Recommended 5th Wheel Rails for a 2024 Chevy Silverado 1500
- Q&A: 5th Wheel Brackets For 2012 Chevy 2500 Truck
- Q&A: How to Determine Which Trailer Roof Vent Cover will Fit a Trailer
- Q&A: Pin Box Replacement Recommendation For A Lippert Road Armor Pin Box
- Q&A: Does Crossmember # RP58147 have a Front and Back and Should it Be at an Angle on Slider Base
- Q&A: List of Replacement Parts for Reese 5th Wheel Trailer Hitch 30047
- Q&A: Will Valley Power Pull Extreme 5th Wheel Hitch Fit Husky Base Rail Kit HT31408-686 in 2008 F-250