Why Can't Factory Hitch of 2006 Dodge Ram Be Removed to Install Curt Hitch
Published 01/15/2016
Question:
Why cant u remove the factory hitch and then install new hitch? Then it wont look so weird?
asked by: Ruchard
0
Expert Reply:
The OEM hitch on your Ram truck is welded to a cross member located behind the rear bumper. The cross member is an integral part of the vehicle structure and should not be removed, according to Curt.
I attached an install video for this hitch part # C15409 for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class V XD - 2"
- Trailer Hitch
- For Towing
- Class V
- 2550 lbs TW
- 17000 lbs GTW
- 17000 lbs WD GTW
- 2 Inch Hitch
- 2550 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What Class V Trailer Hitch do You Have for My 2004 Dodge Ram 3500 with Flatbed and Original Hitch?
- Q&A: What Does B&W Hitch BWHDRH25211 Look Like Installed on a 2012 Ram w/Factory Hitch
- Q&A: Installation Difficulty of Curt Trailer Hitch 15409 for 2006 Dodge Ram 2500 With Factory Hitch
- Q&A: Trailer Hitch for a 2003 Dodge Ram 2500 with Factory Hitch and Hellwig Big Wig Sway Bar
- Q&A: Ground Clearance Dimension for Curt Trailer Hitch Receiver # C15704
- Q&A: Recommended Class V Hitch For A 2005 Dodge Ram 2500 With Tight Bumper Clearance
- Q&A: Recommendation To Replace Damaged Factory Hitch on 2012 Ram 2500
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Determining Trailer Tongue Weight
- Article: What Do I Need To Tow A Trailer?
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Which Hitches are Made in the USA
- Article: RV Pre-Departure Checklist
- Article: Trailer Hitch Installation Tips