Recommended 7-Way Round Trailer Connector And Wiring
Updated 10/27/2015 | Published 10/26/2015
Products Featured in This Question
Question:
Do they make a plug that is 7 pin round and has either pre-molded wiring in straight or coil lengths?
asked by: Patrick H
Expert Reply:
If you are looking for a round connector with a 7-way blade I recommend part # H20046. This is a trailer end connector with 8 ft molded wire. For a 7-way with 6 ft of molded wire you need part # H20044, and for the connector with 4 ft of molded wiring you need part # H20043. for a connector with a coiled wire I recommend the WesBarg 7-Way, RV-Style Connector, part # WG54006-043. This has 6 ft of coiled wire attached.
If you are looking for a 7-way with round pins we do not offer a 7-way round pin connector that has a molded wire or coiled wire. We do carry 7-way round connectors like part # PK11720. This is the vehicle end 7-way round pin connector and it has mounting terminals on the back that you can attach the wiring to.
For the trailer end we offer part # PK11702. This has the cable guard included and you can attach shielded 7-way wire like part # DW04914-1 that is sold by the foot.
Product Page this Question was Asked From
Hopkins 7-Way RV Style Connector with Molded Cable - Trailer End - 8' Long - RV Standard
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 7 Blade
- Plug and Lead
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: pintle hook
- Search Results: 25580
- Search Results: gs 2125dl seal
- Search Results: 15123
- Search Results: pintle hitch
- Search Results: pintle hook ~ standard pintle hitch
- Search Results: wire box
- Article: Trailer Wiring Diagrams
- Shop: Xtreme Heaters RV Basement and Boat Bilge Heater - Small - 400 Watts
- Video: etrailer VS Dexter Self Adjusting Brakes Comparison
- Video: All About the Trailer Wiring Junction Box
- Video: Ultimate Overview of the Buyers Products 45 Ton Pintle Hook
- Q&A: Availability Of Mounting Hardware For Buyers 45 Ton PIntle Hook
- Q&A: Mounting Hole Dimensions of Buyers Products 45 Ton Pintle Hook
- Shop: Bearing Kit, 15123/25580 Bearings, GS-2125DL Seal
- Shop: etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector
- Shop: Bright Way Trailer Breakaway Kit with Charger, LED Tester, and 5 Ah Battery - Side Load
- Q&A: How to Determine the Correct Bow Roller Needed For a 1999 Tidewater Boat Trailer
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Q&A: Do Electric Brakes Need to Share Ground Wire?
- Shop: Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Q&A: Converting Trailer from Surge Brakes to Electric Brakes
- Shop: 7-Way Molded Trailer Wire Connector, 6' Long
- Shop: Yates Bow Roller for Boat Trailers - Heavy-Duty Rubber - 3" Long - 1/2" Shaft
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Brake Controller
- Video: Pollak 7-Way to RV Socket LED Circuit Tester Spec Review
- Shop: Gooseneck Hitch
- Video: Buyers Products Pintle/Combination Hitch Mounting Kit Review