What Amperage Value Fuse to Use When Running Two Optronics LED Trailer Lights # BUL53CB
Updated 10/19/2015 | Published 10/17/2015
Question:
I purchased two BUL53CB revers lights which draw .288 amps each at 12.8v. I will install both on one Circuit. What amp fuse is recommended. Thank You.
asked by: Steve M
Helpful Expert Reply:
Since the Optronics LED Trailer Light # BUL53CB draws only 0.228-amperes, two of them can be fused with as low as a 5-amp fuse (few vehicles will have any lighting circuit fused below a 5-amp value). You should not have to worry about compatibility due to power draw, which is quite moderate for all LED type lights as compared to the incandescent type.
Product Page this Question was Asked From
LED Backup Light for Trucks or Trailers - Submersible - 36 Diodes - Round - Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- White
- Optronics
more information >
Continue Researching
- Q&A: Will Truck Clearance And Cab Marker Light CB22AB Replace PM-120 Cab Light?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Cross Reference a Replacement for a TCM 21334 TB Grease Seal
- Q&A: Trailer Hub Replacement for 2021 Grand Design Reflection 5th Wheel with 5,200 lb Axle
- Q&A: Replacement Grease Seal for Seal with ID of 2.125 and OD of 3.371
- Q&A: Can I Replace 8-14.5 Tires with a Non-Metric Sized Tire
- Q&A: Is 14 Gauge Wire Too Small for Electric Trailer Brakes
- Q&A: Axle Replacement For Tracker Trailstar Trailer