Curt Class I Hitch Part # 11498 for 2008 BMW 535I
Published 06/10/2010
Question:
I need to understand how this hitch attaches to my BMW. What needs to be cut away? thanks,
asked by: John U
0
Expert Reply:
Per the instructions provided by Curt, no fascia trimming is required for installation of this particular hitch. I confirmed this by phone with one of my contacts in Curt Tech Services, as well.
Four holes will need to be drilled for installation, and you will want to make sure to caulk around the bolt holes in the trunk pan after installation to prevent exhaust fumes and water from entering the vehicle.
I will include a link to the installation instructions below.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will the Curt Hitch C11498 for a 2006 BMW 530i Sit Behind Panel On Aero Rear Bumper
- Q&A: Difference Between Curt Trailer Hitches C11174 & C11178 and Bike Rack Options for 2009 BMW 560i
- Q&A: Recommended Trailer Hitch for a 2010 BMW 5 Series Sedan
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Replacement Hub for Trailer With Timken 158123 Inner and 09067 Outer Bearing
- Q&A: Wiring Harness and Brake Controller Set Up for a 2009 BMW X5
- Article: Can You Flat Tow a Jeep Compass?
- Q&A: Trailer Hitch Fit Recommendation for 2007 BMW 530xi Wagon
- Q&A: Troubleshooting T-One Tee Connectors Not Fitting a 2016 Toyota Sienna