Pig Tail Wiring with Load Resistor for Optronics LED Trailer Stop/Turn/Tail Light
Updated 09/01/2015 | Published 08/31/2015
Products Featured in This Question
Question:
What pigtail do you recommend for the Optronics Trailer Lights - STL23RB? Do you need a pigtail with a resister to prevent the fast flashing?
asked by: Darren
1
Helpful Expert Reply:
For Optronics trailer light # STL23RB you can use wiring harness # ALEDRST1B. This harness comes with a load resistor built in to prevent hyper flashing. Hyper flashing is more common when putting LED lights on vehicles and not normally and issue on trailers.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Miro-Flex LED Trailer Light w/Reflector - Brake, Turn, Tail - Submersible - Round - Red - Clear Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Leaf Springs For 2017 Keystone Bullet Premier Travel Trailer
- Q&A: Recommended Replacement For A Dometic 630515.331 AC Rooftop Unit
- Q&A: Looking For Trailer Jack With 1-3/4" Tube Diameter
- Q&A: Looking For Replacement Marker Light SAE A PC2 DOT 17 For A 2022 Surveyor Legend
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper
- Q&A: Replacement For TDE LP75 Disc Brake Actuator
- Q&A: Can Strap of Fulton XLT Powered Winch be Replaced
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Troubleshooting Brake Controller Installations