Parts Needed to Add 4-Pole Flat Trailer Wiring Harness to 2010 Mitsubishi Outlander
Updated 08/31/2015 | Published 08/29/2015
Products Featured in This Question
Question:
To whom it may concern. I have a 2010 Mitsubishi Outlander that has a square connector for the trailer lights. However, my trailer has the standard 4-flat. Do you carry an adapter that would connect the two? Thank you. Best regards.
asked by: Kalon S
Expert Reply:
It sounds like the connector on your 2010 Mitsubishi Outlander that you are referring to may be the one that mates with the wiring harness connector shown in the linked photo. This connector is part of the Curt custom-fit harness # C56102 and the Tow Ready # 118518, both of which fit your 2010 Outlander. Both of these wiring kits provide you with a 4-pole flat connector to activate your trailer's lighting functions. An installation video is linked for you.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- Factory Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Wiring Harness for a 2011 Mitsubishi Outlander
- Q&A: Fifth Wheel Hitch Install Kit for Trucks With Carbon Fiber Beds
- Q&A: Is the Reese Replacement Bolts and Washers # 58133 Compatible with Reese WD System 66152
- Q&A: Replacement Shank Bolts for a Reese Strait-Line Weight Distribution System
- Q&A: Lift Kit Solution to Allow Fifth Wheel Trailer to Sit More Level When Towed
- Q&A: Air Bag Helper Springs for a 2012 Mitsubishi Outlander