How To Determine What Bearings Are Needed On Travel Trailer
Published 08/28/2015
Question:
Wondering what the bearings would be for a 5.30-12 trailer tire
asked by: SHAWN
Helpful Expert Reply:
When replacing bearings on a trailer, you will need to know what size bearings will fit the spindle on your trailer axle. The best way is to remove the old bearings and check for the numbers on the bearing. That way you get an exact match. If you are unable to find the numbers on the bearing, you will need to measure the spindle surface as shown in the attached drawing to make sure you get the right size.
Because the load range can vary on tires that are 5.30-12 it would be difficult to say what size bearing should be used on your system.
Product Page this Question was Asked From
Kenda K353 Bias Trailer Tire - 5.30-12 - Load Range B
- Trailer Tires and Wheels
- Tire Only
- Bias Ply Tire
- Load Range B
- 5.30-12
- 12 Inch
- Kenda
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: Which is Better for Highway Use 4.80-12 or 5.30-12 Trailer TIres
- Q&A: Leaf Spring Replacement for 21-1/2 Spring on 2001 StarCraft Camper
- Q&A: Replacement Axle-Less Trailer Suspension Square Axle 49.5 Hub Face and 38.5 Spring Center
- Q&A: Can a 5.30-12 Size Tire be Replaced with a ST145/R12 Size Tire
- Q&A: Availability of 8-Ply-Rated 5.30-12 Special Trailer Tires
- Q&A: Replacement Bearing Solution for DICO Hub 45263
- Q&A: Recommended 5.30R12 Trailer Tire for Highway Use
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Determine Tire/Wheel Diameter
- Article: Finding the Right Electric Winch
- Article: How Much Does a Boat and Trailer Weigh?
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements