Is the Back of LED Trailer Stop/Turn/Tail Light STL-43RBX Exposed or Sealed
Updated 08/25/2015 | Published 08/24/2015
Products Featured in This Question
Question:
Is the back of the circuit board of part # STL43RBX exposed or is it sealed?
asked by: Burke D
0
Expert Reply:
The back of LED tail light # STL43RBX is exposed but the circuitry and diodes are sealed to prevent water from getting in and shorting out the light. This light uses a plug such as # A47PB so what you would want to do is use some dielectric grease # LT37534 on the pins before plugging it into the light. The grease will repel moisture and help prevent corrosion.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Optronics LED Trailer Light w/ Reflex Reflector - Brake, Tail, Turn - Submersible - Round - Red
- Trailer Lights
- Tail Lights
- Rear Reflector
- Stop
- Tail
- Turn
- Round
- Surface Mount
- Submersible Lights
- LED Light
- 4 Inch Diameter
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Replacement For A Dometic 630515.331 AC Rooftop Unit
- Article: Trailer Lighting Requirements
- Q&A: Replacement D-Shaped Rubber Seal For Frameless Trailer WIndow
- Q&A: How to Measure a Trailer Spindle
- Article: Camping Tips for First-Time RVers
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Taillight Lens for a Forest River R-Pod Camper Model 177
- Q&A: Correct Replacement for GS1719 Grease Seal
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: How to Ground Lights When Re-Wiring Aluminum Frame Snowmobile Trailer
- Q&A: Considerations For Upgrading A Carry-On Utility Trailer To 15" Tires For Long Highway Trips
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: What are the Common Types of Propane Fittings Used on RVs?