Does Metal Mounting Surface have to be a Certain Thickness to Use 2-1/2 Inch Round Light Grommet
Updated 08/25/2015 | Published 08/24/2015 >
Question:
How thick can the material that the light is being mounted in be? e.i. I have side rails that are made out of C channel that is approximately 1?4inch thick
asked by: Glenn C
0
Expert Reply:
Metal that is 1/4 inch thick will work well for the round grommet # A55GB. There isn't a specific metal thickness requirement for the grommet since the light pushing against it when installed is what holds the whole assembly in place.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Rubber Grommet for 2-1/2" Round Trailer Lights - Flush Mount - Open Back
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- 2-1/2 Inch Diameter
- Grommet
- Round
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Troubleshooting Error Codes SH and OL on a Tekonsha Prodigy Brake Controller
- Q&A: What Size Hole Do I Drill In Bed For B&W Gooseneck Turnover Ball In 2026 GMC Sierra 2500 ?
- Q&A: Brake Controller and Install Harness Recommendation for 2025 Ram 1500
- Q&A: Suspension Enhancement for 2024 GMC Sierra 1500 AT4X
- Q&A: Troubleshooting Stuck Brakes with a Tekonsha Prodigy P2 Brake Controller
- Q&A: Wiring Needed to Install Tekonsha Prodigy P2 Brake Controller on 1996 Isuzu Trooper
- Q&A: Wiring Diagram and Instructions for a Tekonsha Prodigy P3 Brake Controller
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Wire an Electric Winch


