Troubleshooting Bulb Out Sensor After Using Bulb Out Adapter C35FR
Published 08/19/2015
Question:
I recently purchased the 7 pin to 7 pin light out señsor bypass for my 2012 Volkswagen Touareg. It is not stopping the error lighting on my Touareg. What to do now? Please advise.
asked by: Friend T
Expert Reply:
Are all of the taillights on your trailer working properly? You may try verifying that all of the taillights are in good working order by running a jumper wire of 12 volts from a vehicle battery to all of the terminals of the trailer connector to verify that everything is working properly.
This may seem like a silly question, but are all of the taillights on your vehicle working properly? If not, the error message would be because of that.
Product Page this Question was Asked From
7-Way to 4-Way/5-Way Trailer Adapter for Vehicles with Lamp-Out Sensors Towing Trailers with LEDs
- Custom Fit Vehicle Wiring
- Wiring Adapters
- Universal Fit
- 7 Blade to 4 Flat
- 7 Blade to 5 Flat
- Plug Only
- CURT
more information >
Continue Researching
- Q&A: Recommended Adapter to Trick the Vehicle Computer Into Thinking a Trailer is Connected
- Q&A: 7-Way to 4-Way Adapter with LED Resistor Solution
- Q&A: What Adapter do I Need to Go From a 7 Blade to a 4 Flat on My 2016 Toyota Tacoma?
- Q&A: Looking For New Wheels And Tires For 1967 Streamline Duke Trailer With 7.00-15 6-Lug Tires
- Q&A: Can the Thule Outset Hitch Mounted Tent Handle the Highway Speeds on My RAV4?
- Q&A: Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Hollywood Racks - Destination E Bike Rack Mounting Light Bar Instructions
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy