Recommended Replacement Side Marker Light for Exiss Horse Trailer

Question

Question:

I must replace a side marker light on my Exiss horse trailer. It is marked as SAE P297 DOT. Can you suggest one of your products that can be used as a direct replacement? Best regards.

asked by: Tom G

0

Expert Reply:

The markings on a trailer light lens are usually not the actual part number for the light, which is most often found on the back or base of the light assembly. But its easy to find the correct replacement using our search options.

If you click on the link provided you'll be able to see our main page for trailer lighting. You can then click the filters on the page to select your lens shape, color, mounting type, bulb type, etc. You can also narrow the results shown based on the light's dimensions. Simply click on the characteristics you need to see the replacements that match.

For example, if you need an amber-color oval-shape surface-mount light we offer # MCL31AB and # MC68AB among others.

expert reply by: Adam R

0

Answer 1

According to Dexter, this is a 3,750 lb torsion axle with a 90.3" hub face measurement. More than likely your axle uses #L68149 and #L44649 bearings with a #168255TB grease seal. You will need to verify this information since Dexter did not have…

view full answer...

Answer 2

In order to tell if you have a factory tow package on your 2022 Kia Sorento, there will be tail light wiring connectors behind the rear driver's side tire. This will be on the exterior of the frame rail. In order to see these ports, you will have…

view full answer...

Answer 3

On your 2014 Ford E350 Van with the factory towing package the brake controller port should be located behind the center of the dash above the stereo. You will need to remove the center panel above the stereo and to the left. Once it is removed there…

view full answer...

Answer 4

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 5

Thank you for reaching out and providing all of your photos! From the pictures you sent in it does look like the Aluminum Jaguar Trailer Wheel #LHSJ211G would be a match since it has the same color scheme, dimensions, and bolt pattern. When I looked…

view full answer...

Answer 6

I'm sure we can get you a pre-greased hub assembly to replace your UFP H1377, but I was unable to find any definitive information on exactly what will replace this hub. So in order to find the correct hubs you will need to take apart your current…

view full answer...

Answer 7

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Recommended Replacement Side Marker Light for Exiss Horse Trailer

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching