How to Wire Superwinch LT3000
Updated 08/17/2015 | Published 08/15/2015 >
Question:
I have a lt3000 Superwinch and hooked it up but am confused on the wiring. It has the handle bar switch and the remote , but cant figure out what post the wires go to on the solenoid and what wires connect to the others . There us two black post and two red post on soleniod. Any help I would be grateful.
asked by: Jerry
Expert Reply:
First you want to make sure you mount the solenoid close to the battery, under the seat or frame or in the storage box. Next route the red wire from the handlebar switch to the ignition switch and connect to the wire that is powered when ignition is in the on position. Then route the two wires from the solenoid to the motor.
Next route the two wires from the solenoid to the battery and attach the circuit breaker to the end of the red wire. Wrap the circuit breaker with electrical tape. Then attach the short circuit breaker wire to the battery positive terminal and reattach the terminal to the battery. Finally connect the remaining black solenoid wore to the battery negative terminal and connect the terminal to the battery.
I have included a link to the installation instructions for you to check out as well.
Product Page this Question was Asked From
Superwinch LT3000 ATV Winch - Wire Rope - Roller Fairlead - 3,000 lbs
- Electric Winch
- ATV - UTV Winch
- Planetary Gear
- 1.0 HP
- 2001 - 4000 lbs
- 11 - 20 lbs
- Slow - 0 to 4 fpm
- Wired Remote
- Wire Rope
- Superwinch
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Solution for Replacement Winch for Old Starcraft Lift System
- Q&A: Locating the Brake Controller Connector on a 2017 Ford F-150 to Install the Hopkins # HM47294
- Q&A: Replacement Shelby 5438 Winch Recommendation for Pop Up Camper
- Q&A: Winch Recommendation for Pulling Racecar Up Into Trailer
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Article: How to Install E-Track in 3 Easy Steps
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Q&A: No Power At Brake Controller On 2007 Chevy Silverado Classic
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper

