Hitch Pin Hole to Bumper Dimension for Curt Hitch part # C12264
Published 08/07/2015
Products Featured in This Question
Question:
on a chrysler 2014 town and country with stow and go, what is the clearance from the center of the hitch hole or pin hole to clear the bumper for a bike rack? For a Curt 1.25inch trailer hitch
asked by: Dan
Expert Reply:
The distance from the center of the hitch pin hole of the Curt Hitch part # C12264 to the furthest point out on the rear bumper of your vehicle would be right at 5 inches.
The most popular bike rack we carry that has been confirmed to fit this vehicle is the Swagman XTC2 Bike Rack part # S64670. This rack has a ton of positive reviews from our customers who have tried it. Check out the review video I attached for more info.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- For Towing
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Does Curt Trailer Hitch FIt 2020 Dodge Grand Caravan With Stow & Go Seating
- Q&A: Recommended Hitch for a 2025 Toyota Grand Highlander
- Q&A: Brake Controller Recommendation for a 2016 Chrysler Town and Country with Factory Tow Package
- Q&A: What is Needed to Install a 7-Way on a 2008 Chrysler Town & Country
- Q&A: Puck Hole Dimensions for the 2022 Chevy Silverado 2500
- Q&A: Replacement Hub for Tie Down Engineering 11033
- Q&A: Replacement Grease Seal for 5,100 Terran Axle
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)