Removing Retainer Ring When Replacing Wobble Roller On Boat Trailer
Updated 08/04/2015 | Published 08/02/2015
Products Featured in This Question
Question:
What is the best way to remove an old wobble roller retainer ring from the roller shaft? I keep breaking them and leaving the end in the hole in the shaft
asked by: Scott
0
Expert Reply:
Taking the retainer ring like part # CE10981 out when removing a wobble roller can be tricky, particularly when they tend to break. My best recommendation is to use two needle nose pliers if you can get a good grip when removing the ring. You can grab both sides at one time and hopefully not have one end slip inside the roller shaft if it should break.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Yates Ribbed Wobble Roller for EZ Loader Boat Trailers - TPR - 1" Shaft
- Boat Trailer Parts
- Rollers
- Wobble Roller
- 3 Inch Wide
- 5 Inch Diameter
- Plastic
- Fits 1 Inch Shaft
- Yates Rubber
more information >
Continue Researching
- Q&A: Are Powder Coat Trailer Wheels Good for a Saltwater Boat Trailer ST205/75R14
- Q&A: Wobble Roller, Hog Ring and Washer for an EZ Loader Boat Trailer
- Q&A: Does Titan Brake Line Tee Secure Trailer Brake Lines
- Q&A: Dexter Vault Hub Service Kit Replacement Kits
- Q&A: Will Ultra-Fab 5th Wheel King Pin Shroud Fit Pin Box On 2012 Infinity 3750L Trailer
- Q&A: Boat Trailer Wobble Rollers for 1 Inch Diameter Shaft
- Q&A: Replacement Rollers and Fenders For 1996 Shorelandr Trailer
- Article: How to Measure a Trailer Axle
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: Best Boat Trailer Jacks
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer