Do Factory Bump Stops Get Trimmed to Install AirLift Air Bags on a 2004 Chevy Venture
Published 08/01/2015
Question:
I have a 2004 Chevy venture 2 wheel drive do you have to remove the bumps stops on the top of the springs or cut them or just leave in place. Do I have to remove the springs or just squeeze them inlace when you the suspension on a jack
asked by: Angelo.
0
Expert Reply:
When installing AirLift 1000 system # AL60748 you will need to cut off the bottom 2 sections of the factory bump stops on your 2004 Chevy Venture. There would not be enough room otherwise. I have included a link to the installation instructions for you to view as well.
expert reply by:
Michael H
0
click to enlarge
Product Page this Question was Asked From
Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Light Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Firestone Air Bags for 2026 Ford F-350 FX4 Dually
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Comparing the Curt Hitch C13416 and EcoHitch Hitch 306-X7396 for a 2019 Toyota RAV4
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector