How to Wire Up the Switch of the Halogen Docking Light Kit DL-16CC
Published 07/31/2015
Question:
Where do I ground the 55 watt halogen lights on my pontoon boat? Do the negative run ONLY to the top of the switch, positive to middle and the fuse straight to the pos terminal on the battery?
asked by: Moses
0
Expert Reply:
On a boat you would want to ground docking lights # DL-16CC to the negative battery terminal.
The pin on the top of the switch runs to the ground, the middle supplies power for the lights, and the bottom pin runs to the positive post of a battery through a fuse.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Halogen Docking Light Kit - 35 Watt - Lighted Switch and Safety-Fused Wiring - Black Housing
- Boat Lights
- Docking Lights
- Deck
- Black Housing
- Surface Mount
- Halogen Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Will The Curt Trailer Hitch Receiver C82RJ Fit The 2027 Kia Telluride
- Q&A: Is There a Support Brace Designed for the Replacement Crank Extension for Lippert Spare Tire Winch?
- Q&A: Replacement LED Flood Light for Load Lights on a Horse Trailer
- Q&A: Recommended 4" x 6" Utility Work Light
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: How To Install the ThinLine LED Light As An Identification Light On Trailer Over 80 Wide
- Q&A: Why Do I Need to Disconnect the Battery to Flat Tow a 2022 GMC Sierra 1500 AT4?
- Q&A: Replacement 12 Inch Brake Assemblies for Redline EB01-140 and EB01-145 From Dexter Axle
- Article: Carrying on a Legacy: One Family’s Story of Grief, Growth, and a Global Pandemic
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: 2024 Top Gifts For Outdoor Enthusiasts