Where is the Curt Class I Hitch # C11391 Manufactured
Updated 07/23/2015 | Published 07/22/2015
Products Featured in This Question
Question:
is the Curt Trailer Hitch for the 2012 Civic Made in USA ? Thanks.
asked by: Andy
0
Expert Reply:
The Curt Class I hitch, part # C11391, is made in the USA and includes a pin and clip. Note that if used with any non-trailer load, say a bike rack or cargo carrier, Curt requires you to use their stabilizing strap # 18050 which is not a requirement for the Draw-Tite.
A helpful hitch install video and article are linked for you.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Can 2009 Honda Civic Tow 1,000 lb Trailer
- Q&A: Trailer Hitch Recommendation for a 2009 Honda Civic SI Sedan
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Hitch Recommendation for a 2015 Honda Civic Coupe Si
- Q&A: Recommended Hitch Receiver for 2015 Honda Civic Towing Jet Ski Trailer
- Q&A: Recommended Hitch for a 2017 Honda Civic Coupe
- Q&A: Can Curt Tow Bar be Used with Blue Ox Base Plate Kit
- Article: Rolling on a Budget: Top Wallet-Friendly Platform Bike Racks
- Article: Trailer Hitch Installation Tips
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Wiring Diagrams
- Article: Trailer Hitch Receiver Sizes
- Article: Performance Chips and Modules