Does the Spare of a 2000 Mitsubishi Get Reinstalled After Trailer Hitch Install
Updated 06/25/2015 | Published 06/24/2015
Question:
Just installed 13223. The spare tire wont fit back up. It squeezes in too tight between the back of the hitch and a round cross bar on the front side. Any suggestions?
asked by: Dale H
0
Expert Reply:
Sometimes after you install a hitch when you go to reinstall the spare tire you end up having to angle the spare as you raise it back into position so that it will fit correctly.
Check out the install video I attached for this hitch that shows our installer removing the spare and then reinstalling it once the hitch has been installed.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Is The Curt C13800 Hitch For A 2001 Mitsubishi Montero A No-Drill Install?
- Q&A: Trailer Hitch for 2001 Mitsubishi Montero Limited
- Q&A: Replacement Power Center For Magnetek 6700 on a 1999 Niagara Camping Trailer
- Q&A: Which Motorcycle Carrier Is Best For Yamaha TW 200?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Recommended Hitch for a 2023 Honda Passport
- Q&A: Will Curt Class 3 Trailer Hitch, # 13223, Fit A 2002 Mitsubishi Montero Sport