What is the Melting Point of Trailer Light Rubber Grommet A45GB
Updated 06/18/2015 | Published 06/17/2015
Products Featured in This Question
Question:
How high a temp.is the rubber good to.
asked by: Richard
Helpful Expert Reply:
The type and composition of rubber is going to determine its melting point. Rubber grommet # A45GB is a lower grade than tires so it is on the lower end of the scale. Rubber components can start to melt at 160 to 356 degrees Fahrenheit. The grommet, being at the lower end, is likely in the 160 to 200 degree range but its melting point has never been officially tested. The lights this grommet is designed for are not made for high temperature applications which is why it is on the lower end of the scale.
Product Page this Question was Asked From
Miro-Flex LED Trailer Light w/Reflector - Brake, Turn, Tail - Submersible - Round - Red - Clear Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Recommended Replacement For A Dometic 630515.331 AC Rooftop Unit
- Q&A: Replacement For TDE LP75 Disc Brake Actuator
- Q&A: Can Strap of Fulton XLT Powered Winch be Replaced
- Q&A: Replacement Passenger Side Miro-Flex LED Trailer Light 38 Diode
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Q&A: Comparing Bearing Buddy and Kodiak Red Eye Trailer Bearing Protectors
- Q&A: Installing a Trailer Brake Controller on a 2004 Toyota Highlander with Tow Package
- Q&A: Replacement A-Frame Jack For Atwood Mobile Product Jack On Trailer With 2" Diameter Mounting Hole
- Article: Trailer Wiring Diagrams
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Troubleshooting Brake Controller Installations
- Article: Trailer Lighting Requirements