Removal of the Snap-on Reflector Ring # A78RXB
Updated 05/28/2015 | Published 05/26/2015
Question:
I struggle to get these off. What is the best way. If I break one, I see that I can buy more from you.
asked by: Randy
Helpful Expert Reply:
The Snap-on Reflector Ring # A78RXB that you referenced attaches at the top, bottom, left, and right of the mounting flange of the light assembly with clips that slip over the flange when pressed on.
To remove the ring you basically would want to grab one side of the ring and gently pry up on the ring till it releases from the mounting flange. If it does not want to remove this way you can use a thin slot screwdriver and slide it down into the slots on the sides of the light. This will allow you to push on the hooks of the ring so that they will release from the light. See picture to see where to insert the screwdriver.
Product Page this Question was Asked From
Snap-on Reflector Ring for Flange or Surface Mount Trailer Lights - Red
- Accessories and Parts
- Trailer Lights
- Light Trim
- Red
- Optronics
more information >
Continue Researching
- Q&A: Best Lug Nuts for 2021 Keystone Cougar 29RKS
- Article: Trailer Lighting Requirements
- Q&A: How Do Safety Chains of Andersen Ultimate Safety Chain Kit Attach to Fifth Wheel Rail
- Q&A: California Required Safety Chains for Andersen Ultimate Hitch
- Q&A: Replacement Oil Cap for Dexter Hub # 21-35
- Q&A: Width of Tandem Axle Teardrop Trailer Fenders for Boat Trailers
- Article: The Best Towing Mirrors
- Q&A: Is Snap On Reflector Ring part # A78RXB Optronics Brand Replacement Part
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Q&A: Optronics LED Trailer Lights # STL78RLPB Package Contents
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Raise Your Travel Trailer Height
- Article: Frequently Asked Questions About Transmission Coolers