How Does the Lock Circuits of Truck Get Tested When Installing Pop and Lock Tailgate Lock
Updated 05/27/2015 | Published 05/25/2015
Products Featured in This Question
Question:
When testing for the correct circuit do you operate the locks and test the wire for voltage?
asked by: Dave
0
Expert Reply:
Yes, to test the wires of your vehicle locks for the install of the Pop & Lock Custom Tailgate Lock # PAL8250 you would need to operate the locks with a circuit tester like part # PTW2993 attached to the circuit.
I attached an install video for this lock system for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Power - Black
- Tailgate Locks
- Lock Only
- Power Lock
- Keyed Alike
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Looking For Electric Brakes And Hub/Drums For Lippert 3,500 lb Axle
- Q&A: What are the Correct Bearings, Races, and Seals for 4,400 Pound Axle?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Selection of Timbren Rear Axle Suspension Kit for 2006 Ford F250 Crew Cab Short Bed 4WD
- Q&A: Replacement Brake Shoes For Al-KO 10" X 2-1/4" Electric Brake Drums On a 2002 Forest River Flagstaff
- Q&A: Which Timken Grease Seal for Trailer Hub Replaces GS-1719 DL
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Which Pop and Lock Tailgate Lock Will Fit 2004 Ford F-150 With Power Locks and Non-Locking Tailgate
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices