Should the Curt Hitch C13163 for a 2014 Mitsubishi Outlander Stick Out Past Rear Bumper
Updated 05/15/2015 | Published 05/14/2015
Question:
Hello, I have a Curt C13163 installed on my 2014 Outlander. The receiver is about two inches stick out from the rear bumper when I see from the top instead of flush to the bumper. I was wondering if it is what the design supposed to be. Thanks.
asked by: Leo L
1
Helpful Expert Reply:
Sounds like you installed the Curt Hitch part # C13163 correctly on your 2014 Mitsubishi Outlander. This hitch is supposed to stick out a little bit when installed.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 600 lbs TW
- 4000 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Difference Between The Curt & etrailer Class III 2 Hitch Receiver
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: 2016 Mitsubishi Outlander Recommended Towing Parts
- Q&A: Trailer Wiring Harness that Fits 2019 Mitsubishi Outlander
- Q&A: Replacement 12-1/4 x 5 Brake Assemblies For a 15,000LB Dexter Axle
- Q&A: Replacement Lower Assembly and 2" Stinger for Thule T2 Pro XTR 2-Bike Rack
- Q&A: Replacement Bearings 2788 and 1779
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Will Replacement Solenoid Fix Weak Hydraulic Slide-Out
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Trailer Hitch Installation Tips
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)